From minor seepage to full basement flooding, JCB Waterproofing and Construction provides engineered solutions that protect your foundation and your investment.
Four reasons why Centre homeowners trust us with their most important asset.
Our interior drain tile systems are sized and sloped to specification, ensuring gravity carries water to your sump pump without clogging or backing up over time.
Porous concrete block and poured walls let groundwater seep through at the mortar joints -- we seal them from the inside with hydraulic cement and crystalline coatings that bond permanently.
Our team is not seasonal labor -- these are career waterproofing professionals who have installed hundreds of systems and troubleshoot the edge cases that stumpers other companies.
We deliver detailed written quotes that break down every material and labor cost -- no surprise line items appear on your final invoice that were not on the original estimate.
Hydrostatic pressure is the invisible force behind nearly every basement water problem homeowners face in Centre, AL. When soil around your foundation becomes saturated -- whether from heavy rain, snowmelt, or a high water table -- it exerts outward and downward pressure against concrete walls and floor slabs that can exceed hundreds of pounds per square foot. Over time, this pressure finds the smallest weakness: a tie rod hole, a cold joint between wall and footing, a shrinkage crack in poured concrete, or a deteriorated mortar joint in block construction. Once water finds its path, that path widens with every wet season until a trickle becomes a flood.
Interior drain tile is the most reliable and widely proven basement waterproofing method for existing homes in AL because it manages water that has already entered the wall cavity rather than attempting to stop it at the exterior. The system consists of a perforated pipe, encased in clean washed gravel, installed at or below the footing level in a channel cut along the perimeter of the basement floor. Water that enters the wall-floor joint, seeps through cracks, or migrates through porous concrete flows into this channel and is directed by gravity to a sump basin. A properly sized sump pump then discharges the water away from the foundation. When correctly installed, this system operates indefinitely without clogging because the inlet is protected from sediment by the gravel bed and a filter sock on the pipe.
Wall seepage in block-construction basements is distinct from crack injection because the water is not coming through a single discrete opening -- it is migrating through the porous masonry itself and weeping through the mortar joints. Effective treatment requires sealing the interior face of the block with a hydraulic cement parging coat, followed by a crystalline waterproofing compound that reacts with moisture to form insoluble crystals inside the concrete matrix. This approach stops the migration rather than coating over it, producing a result that actually strengthens with repeated moisture exposure rather than degrading. For severe seepage, core-filling the hollow block cells with grout eliminates the cavity that allows water to travel vertically inside the wall before finding an exit point.
Window wells in below-grade basement windows are a frequently overlooked water entry point. When the well fills with rainwater faster than the soil at the bottom can absorb it, that water presses directly against the window frame -- typically the weakest point in the entire basement envelope. We address window wells with a dedicated drain assembly at the base of the well, tied into the interior perimeter drain system, combined with a properly sized and anchored polycarbonate cover that deflects rain while allowing emergency egress.
A complete basement waterproofing system also requires a reliable, properly maintained sump pump installation. We specify sump pits that are large enough to accommodate both a primary pump and a battery backup pump with sufficient separation that the backup does not interfere with the primary float. Discharge lines are routed to daylight at a point that ensures water flows away from the house and cannot recirculate back to the foundation. Battery backup systems are sized to handle a sustained pumping load during a power outage -- not just a brief test cycle -- because the storm events that knock out power are precisely the events that generate the highest water volume in your basement.
Our full-service waterproofing menu addresses every water entry point from foundation wall to window well.
Perimeter drain channels installed at footing level route water from wall-floor joints to a central sump basin, eliminating standing water completely.
Injection ports are removed after cure and the wall surface is patched flush, leaving a clean repair with no visible hardware remaining on the wall face.
We install pedestal and submersible sump pumps from commercial-grade manufacturers and include a battery backup unit as standard on every new installation.
For severe seepage through block walls, we add core-filling with cementitious grout to eliminate the internal cavities that allow water to travel vertically inside the wall system.
In cases where floor heaving or settlement accompanies the crack, we supplement injection with a partial slab replacement to restore a flat, properly sealed surface.
Below-grade window wells that collect rainwater are fitted with a dedicated drain at the base of the well, connected directly into the interior perimeter drain system.
We measure moisture levels at multiple points, probe for efflorescence sources, and map every water entry location before recommending any solution.
We prepare a detailed written scope covering all materials, methods, and warranty terms before scheduling any work so you know exactly what you are approving.
Our certified crew completes the installation with minimum disruption to your home, working from a phased sequence designed to protect furnishings and maintain basement access throughout.
We perform a complete post-installation inspection, take final moisture readings, and walk you through the system before issuing your written warranty documentation.
We had serious standing water every spring for eight years. JCB Waterproofing and Construction installed a full perimeter drain and sump system and we have been completely dry through two wet seasons since.
The quote was detailed, the crew was on time, and the work was exactly as described. They even patched the concrete so neatly you can barely tell there was a drain trench cut.
I called three companies before choosing JCB Waterproofing and Construction. They were the only ones who actually measured the moisture levels and explained what was causing our specific problem before quoting a fix.
Don't let another wet season damage your foundation. Contact JCB Waterproofing and Construction today for a no-obligation waterproofing assessment in Centre, AL.
Call +1-866-476-1348 Now